DINOSAUR ELECTRONICS - The FAN 50 Plus Pins is designed to replace the new Suburban« Fan Control boards and the Atwood« / HydroFlame« Fan Control boards as well as the Dinosaur Fan Control boards which have been available since 1994. This board can also be used to upgrade older furnaces to add the Fan Control feature.The basic purpose of a Fan Control Ignitor Board is to shut the fan motor off if the board fails to sense a flame after the third ignition try. Thus, battery drain is reduced and the needless blowing of cold air is eliminated. The FAN 50 Plus Pins, after shutting the fan motor off, will wait for 1 hour and repeat the whole sequence again before permanent shut down. For 12V DC Furnaces ONLY! The ôFan Controlö feature MUST BE USED for proper operation of this board. Features: ò Jumper selectable operation. ò Works in 12V DC furnaces*. ò Microcontrolled. ò 3.35" x 4.25". ò Diagnostic LED. *Note: Fan control boards should not be used in DuoTherm« 900 series furnaces that have the thermostat in the ground circuit. Ignitor Board, Fan 50 Plus Pins.
Featured articles
5 Things You Must Know Before Buying a Used RV
Looking to buy a used RV but a little unsure of where you should start? Do you want some more information before...
Why Buying Used RV Parts is a Bad Idea
Used RV Parts can be unsafe and can actually cost you more in the long run. If just one component fails, your...
RV Camping With Dogs: 9 Tips For Traveling With Your Pet
Exactly right: "Before getting a dog, you have no idea what life with one might be like; afterward, you can't imagine...
Experts Advice on Camping Tents: Online
The process of buying Tents For Sale can be extremely complicated if you have never purchased one or are shopping for...
The 10 Best Grilling Essentials for Any Outdoor Cooking
Outdoor cooking and RVing are closely related. A major advantage of having an RV is that you can bring your own...
English